Parr-instrument PDM Manual de usuario descargar pdf (Pagina 6)

- 6 -

PDM Installation

Final Steps

Close the controller and replace the two screws on the back panel. Plug the 4838 controller back in,

and turn it on. The PDM display should read zero when the motor is not turning.

It is useful to check that the settings on the display are set correctly. Check these against the defaults

listed in the back of these instructions.

Meter Pin Outs

2082E Color: Attaches to:

Pin 1 Black Terminal Block 4

Pin 2 White Terminal Block 3

Pin 3

Pin 4 White A2104E Harness Pin 1

Pin 5

Pin 6 Black A2104E Harness Pin 2

Pin 7 Orange 2083E Primary Temp

Controller Terminal 14

Pin 8 Blue Terminal Block 3

Pin 9

Pin 10

Pin 11 White 2083E Primary Temp

Controller Terminal 10

Pin 12 Black 2083E Primary Temp

Controller Terminal 9

2083E Color: Attaches to:

Pin 1 Violet 1119E SSR Terminal 4

Pin 2 Red 1119E SSR Terminal 3

Pin 3 T/C Cable RTD only T/C Jack (-) RTD

Pin 4 T/C Cable T/C Jack (+)

Pin 5 T/C Cable T/C Jack (-)

Pin 6

Pin 7

Pin 8

Pin 9 Black Comm Receptacle Pin 5

Pin 10 White Comm Receptacle Pin 3

Pin 11 Black Terminal Block 4

Pin 12 White Terminal Block 2

Pin 13

Pin 14 Orange 542E High Limit Switch

Position 2

Pin 15 Blue Terminal Block 3

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Parr-instrument PDM Manual de usuario Pagina 6